8
ERGONOMICS
8.11
Adjusting the basic position of the foot brake lever
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and engage the gearing.
0 0 A
A
–
Locate and tighten screw
402300-10
Guideline
Screw, shift lever
–
Disconnect spring
–
Loosen nut
–
Remove screw
–
To adjust the basic position of the foot brake lever to individual requirements, turn ball
joint
602628-10
–
Hold ball joint
Guideline
Remaining chassis nuts
of the shift lever and shift shaft.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle components
during the shift procedure.
with washers.
M6
.
.
.
accordingly.
Info
The range of adjustment is limited.
The screw must be screwed into the ball joint by at least 5 turns.
and tighten nut
18 Nm
(13.3 lbf ft)
.
M6
81
Loctite
®
243™
10 Nm (7.4 lbf ft)