Changing The Turn Signal Bulb - KTM 1190 ADVENTURE Owner's Manual

16 ELECTRICAL SYSTEM
16.11

Changing the turn signal bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Finishing work
–
Refit the headlight mask with the headlight. (
–
Install the wind shield. (
–
Install the mask spoiler.
–
Install the tank cover. (
–
Install the front side cover. (
–
Mount the driver's seat. (
–
Mount the passenger seat. (
–
Check the headlight setting. (
–
Remove the screw on the front of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
M00605-10
Turn signal (RY10W / socket BAU15s) (
p. 134)
( p. 127)
p. 132)
p. 123)
p. 109)
p. 108)
p. 179)

.

carefully into the socket, turn it counterclockwise by about 30°, and pull
p. 174)
p. 214)
178