Related Manuals for Sena 3S
Summary of Contents for Sena 3S
- Page 1 Bluetooth ® Headset & Intercom for Scooters and Motorcycles User's Guide www.sena.com...
- Page 2 Hero4 allowing for Bluetooth capabilities. The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Sena is under license. iPhone, iPod touch are ® registered trademarks of Apple Inc. Zumo is a trademark of Garmin Ltd.
-
Page 3: Table Of Contents
Installing the 3S on Your Helmet - Wired Microphone Type ......9 Delete All Bluetooth Pairing Information ............. 25 Installing the 3S on Your Helmet - Attachable Boom Microphone Type ..11 Reset to Factory Default Setting ..............26 Powering On ....................13 Exit Voice Configuration Menu .............. -
Page 4: Introduction
• Bluetooth stereo headset for Bluetooth stereo devices such as MP3 players Thank you for choosing the Sena 3S, Bluetooth Headset and Intercom for • Bluetooth stereo headset for Bluetooth GPS navigations Scooters and Motorcycles. With the 3S, you can call handsfree on your •... -
Page 5: Package Contents
2. PACKAGE CONTENTS Status LED (–) Button Pin-hole (Intercom) Reset Button USB Power & Data Cable Speakers (+) Button (Phone, Music) Microphone Sponges Hook and Loop Fasteners Microphone for Speakers DC Power Charging & Firmware Upgrade Port Boom Microphone Type... - Page 6 Status LED Pin-hole Reset Button (+) Button USB Power & Data Cable Hook and Loop Fasteners (Phone, Music) for Speakers Speakers Double Sided Adhesive Tape Hook and Loop Fastener for Microphone (–) Button (Intercom) Microphone DC Power Charging & Firmware Upgrade Port Wired Microphone Type...
- Page 7 Status LED Pin-hole Reset Button (+) Button (Phone, Music) USB Power & Data Cable Attachable Boom Microphone Speakers Microphone (–) Button connector Hook and Loop Fasteners Hook and Loop Fastener (Intercom) for Speakers for Microphone DC Power Charging & Firmware Upgrade Port Microphone Sponges Double Sided Adhesive Tape Attachable Boom Microphone Type...
-
Page 8: Getting Started
3. GETTING STARTED Installing the 3S on Your Helmet - Boom Microphone Type 1. Peel off the hook fasteners for the speakers and attach them on the back sides of the speakers. 2. Attach the loop fasteners for the speakers in the deep ear pockets of your helmet. -
Page 9: Installing The 3S On Your Helmet - Wired Microphone Type
Installing the 3S on Your Helmet - Wired Microphone Type 1. Peel off the hook fasteners for the speakers and attach them on the back sides of the speakers. 2. Attach the loop fasteners for the speakers in the deep ear pockets of your helmet. -
Page 11: Installing The 3S On Your Helmet - Attachable Boom Microphone Type
Installing the 3S on Your Helmet - Attachable Boom Microphone Type 1. Peel off the hook fasteners for the speakers and attach them on the back sides of the speakers. 2. Attach the loop fasteners for the speakers in the deep ear pockets of your helmet. -
Page 13: Powering On
Charging the 3S You can charge the 3S by connecting the supplied USB power & data cable into a computer USB port or USB wall charger. You can use any standard micro-USB cable to charge the 3S. The LED turns red while charging, and turns blue when the headset is fully charged. -
Page 14: Checking Battery Level
2 flashes Low, 0~30% 1. The USB power & data cable is also used for firmware upgrade of the 3S. 2. The USB wall charger is not included in the package. Any 3rd party USB charger can be used with Sena products if the charger is approved by either Voice Prompt Indicator FCC, CE, IC, or other locally approved agencies that Sena accepts. -
Page 15: Adjusting The Volume Level
Fault Reset Adjusting the Volume Level When the 3S is not working properly or is in faulty status for any reason, You can easily adjust the volume by pressing the (+) Button or the you may reset by pushing the pin-hole reset button on the left speaker (–) Button. -
Page 16: Operation Quick Reference
Function Operations 4. OPERATION QUICK REFERENCE 5 sec. Sena 3S v1.1 Function Operations 1 sec. 1 sec. 1 press 1 press Bluetooth Power Select Sena 3S On/Off Pairing (Phone, MP3, Power On Power Off GPS) 1 press 1 press Sena 3S v1.1 Volume Sena 3S v1.1... - Page 17 Operations Operations Function Function 1 press 1 sec. Answer 2 sec. 2 sec. Music 3 sec. 2 sec. Mobile Phone Voice Dial 3 sec. * You can use “Voice Dial” and “Redial” only in stand-by mode. 2 sec. Reject...
-
Page 18: Pairing And Using The 3S With Bluetooth Devices
2. To pair the second mobile phone, press and hold the (–) Button for 1 Turn on the 3S and press and hold the (+) Button for 5 seconds until 5 seconds until the red LED is rapidly flashing and you hear multiple the LED flashes red and blue alternately and you hear multiple beeps. -
Page 19: Bluetooth Stereo Device Pairing
1. If the Bluetooth stereo device is integrated with the mobile phone such as smartphones, you don’t need to pair the 3S with it separately. When the 3S is paired with the mobile phone, it is also paired as a stereo music device. - Page 20 Sena 3S in the list of the devices detected on the GPS. A2DP 4. Enter 0000 for the PIN. 5. The GPS confirms that pairing has completed and the 3S is ready to use. You will hear a voice prompt from the 3S saying “Your headset is paired”.
- Page 21 Bluetooth stereo music source, you can pair the GPS to the 3S by following the simple procedures in “Mobile Phone Pairing”. When you do this, the 3S thinks the GPS is a mobile phone. But the 3S can directly pair an additional mobile phone.
-
Page 22: Mobile Phone Call Making And Answering
You can listen to stereo music by Bluetooth wireless stereo. The Bluetooth 4. To reject a call, press and hold the (–) Button for 2 seconds until you audio device must be paired with the 3S by following the “Bluetooth Stereo hear a beep while the phone is ringing. -
Page 23: Intercom Conversation
1. When you have an incoming mobile phone call during an intercom 1. Turn on the two 3S headsets (A and B) that you would like to pair with conversation, you will hear a ring tone. You can choose whether to 1) each other. -
Page 24: Intercom Failure
(–) Button. If your intercom friend goes out of range while having an intercom 4. If any button is not pressed within 10 seconds, the 3S will exit the conversation, you may hear static noise and eventually the intercom will configuration and goes back to standby. -
Page 25: Enabling/Disabling Voice Activated Phone Answering
VOX feature does not work if you are connected to intercom. To delete all Bluetooth pairing information of the 3S, press the (+) Button This is enabled from the factory but you can disable this. If this mode is until you hear a voice prompt, “Delete all pairings”, and press the (–) -
Page 26: Reset To Factory Default Setting
“Delete all pairings” Execute Execute “Factory reset” To restore factory default settings on the 3S, press the (+) Button until you hear a voice prompt, “Factory reset”. Press the (–) Button to confirm. “Exit configuration” Execute The 3S powers off with a voice prompt, “Headset reset, goodbye”. -
Page 27: Firmware Upgrade
8. FIRMWARE UPGRADE The 3S supports firmware upgrade function. Please visit Sena Bluetooth web site at www.sena.com to check the latest software downloads. Boom Microphone Type Wired Microphone Type... -
Page 28: Certification And Safety Approvals
This product is CE marked according to the provisions of the R&TTE radio communications. However, there is no guarantee that interference Directive (99/5/EC). Hereby, Sena declares that this product is in will not occur in a particular installation. If this equipment does cause... -
Page 29: Industry Canada Statement
Bluetooth SIG, Inc. from uncontrolled waste disposal, please do not dispose of these and any use of such marks by Sena is under license. Other trademarks and products as unsorted municipal waste, but hand it in at an official trade names are those of their respective owners. -
Page 30: Safety Information
SAFETY INFORMATION • Do not store the product in humid environments, especially for long time storage. Please ensure that the product is properly used by observing the Product Use warnings and cautions below to prevent any risk and/or damage to •... -
Page 31: Battery
• Any 3rd party USB charger can be used with Sena products if the charger is approved by either the FCC, CE, IC or other locally approved agencies that Sena accepts. -
Page 32: Product Warranty And Disclaimer
Here, product warranty extends to the and/or cause accidents. product only. Sena will not be liable for any loss, damage of human • Never use a damaged charger. It may explode and/or cause life, or loss of property which may result from using the product beyond accidents. - Page 33 Therefore, of Sena (collectively referred to as “the company”) recommend be certain to read and understand the following terms and conditions that, before using the product and similar devices of any brands before using the product.
-
Page 34: Warranty Exclusions
• When you use the product, use good judgment; never use it under have occurred while you use the product. Further, Sena will not be liable the influence of alcohol. - Page 35 In addition to damages which may occur due to the use of the product, ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN Sena will not be liable for damages of the product which occur due to CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, the following events.
-
Page 36: Warranty Service
Unless you return the product within 14 days from the purchase date, you will have read and agreed to all the terms and conditions explained above, and Sena will not be liable for any claim for damages related with the product. - Page 37 1.1.3 www.sena.com User's Guide for Firmware v1.2...
Need help?
Do you have a question about the 3S and is the answer not in the manual?
Questions and answers