Use Of Wired Remote Controller Installation / Service Mode - Samsung MIM-E03*N User Manual

Use of wired remote controller installation / service mode

Use of installation/service mode
Sub-menu
Main menu
1. If you want to use the installation/service mode for your wired remote controller, press the Set and ESC buttons at
the same time for more than 3 seconds.
f You will enter the installation/service settings, and the 'main menu' will be displayed.
f
2. Refer to the list of installation / service setting mode for your wired remote controller on the next page, and select
the desired menu.
f Using the [∧]/[∨] buttons, select a main menu number and press the [＞] button to enter the sub-menu setting
f
screen.
f Using the [∧]/[∨] buttons, select a sub-menu number and press the [＞] button to enter data setting screen.
f
f When you enter the setting stage, the current setting value will be displayed.
f
f Refer to the chart for data settings. f
f Using the [∧]/[∨] buttons, change the setting value. Press the [＞] button to move to the next setting value.
f
f Press the Set button to save the setting value and exit to the sub-menu setting screen. f
f Press the ESC button to exit to normal mode.
f
• When setting the data, you can move SEG range with [＜] / [＞] buttons.
• While configuring the setting, press the ESC button to exit to the sub-menu setting screen without saving your
NOTE
changes.
• When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.
SEG Used
1 2 3 4
ENGLISH-32