Exclusion Of Liability - Gigaset S820H User Manual

Service (Customer Care)
The caller's number is not displayed.
1. Caller ID is not enabled for the caller. ¥
The caller should ask his network provider to enable Caller ID.
2. Caller ID (CID) is not supported by the network provider or has not been enabled for you.
¥
Have Caller ID (CID) enabled by your network provider.
3. Your telephone is connected via a PABX or a router with an integrated PABX (gateway) that does not trans-
mit all information.
¥
Reset the system: briefly pull out the power plug. Reinsert the plug and wait until the device restarts.
¥
Check the settings on the PABX and activate phone number display, if necessary. To do this, search for
terms such as Caller ID, calling line identification, phone number identification etc. in the system's
user guide or ask the system manufacturer.
You hear an error tone when keying an input.
Action has failed/invalid input. ¥
Repeat the process.
Read the display and refer to the user guide if necessary.
You cannot listen to messages on the network mailbox.
Your PABX is set to pulse dialling. ¥
Set your PABX to tone dialling.

Exclusion of liability

Your handset's display has a resolution of 240x320 pixels. Each pixel consists of three subpixels
(red, green, blue).
It may be the case that a pixel is incorrectly controlled or has a color deviation. This is normal
and no reason for a warranty claim.
The following table shows the number of pixel errors that may occur without leading to a war-
ranty claim.
Description
Color illuminated subpixels
Dark subpixels
Total number of colored and dark subpixels
Please note
Signs of wear on the display and housing are excluded from the warranty.
44
Maximum number of permitted pixel errors
1
1
1
en fr es