Table of Contents
Advertisement
7.
With Knitter Clamps
"L", secure foot
of
Push-up Cams
"M" on
table.
DO NOT USE TOO MUCH FORCE.
8. Raise both Push-up Cams in
arrow direction.
9. On back
of
left
side of
Ribber, insert Swing
Handle
shaft
"N"
from
underneath into Swing Bearing
"0".
Push Handle in
a
twisting manner until
you
hear
a click
with
a
slight jerk.
Ensure that Pointer "P"
on
Swing Indicator
"Q"
moves
when
turning Handle
to
the left and the
right.
10. Set Half-Pitch Lever "R"
to
P (left
side).
By turning Handle,
set
Indicator Pointer
"P" at 5 on
upper
scale
P.
CHECK POINT
When joining Ribber
to Knitter has been finished,
check
the positioning
of
Ribber
against Knitter
by
pushing up
several needles on both beds
up
.
The
needles on both beds
must confront with each other as shown.
If
not, loosen Ribber Joiner Screws and Clamps securing
Push-up Cams, then pat lightly either end of Ribber. Then
fasten them again.
The needles pushed up must be back
to
original position.
-
54
-
Hide quick links:
Advertisement
Chapters
Table of Contents
