Do you have a question about the 560 and is the answer not in the manual?
Questions and answers
Cindy Hatley
April 7, 2025
how can I remove the shaft for the feeder dog gear to replace the gear
1 comments:
Mr. Anderson
April 7, 2025
To remove the shaft for the feeder dog gear on a Singer 560 to replace the gear, you need to:
1. Remove the power supply to access the gear set. 2. Remove any keeper rings or set screws holding the shaft. 3. Slide the shaft out carefully to free the gear. 4. Replace the gear. 5. Reinstall the shaft, aligning any flat spot on the shaft with the set screw. 6. Reattach the keeper ring to secure the shaft.
Synchronization may be needed after reassembly.
This answer is automatically generated
Alda
June 25, 2025
How do I thread the tension regulator? Singer Diana 560 (1979)
Margaret Veltrirobb
March 1, 2025
the feet on the feeder have seized..not moving at all
Need help?
Do you have a question about the 560 and is the answer not in the manual?
Questions and answers
how can I remove the shaft for the feeder dog gear to replace the gear
To remove the shaft for the feeder dog gear on a Singer 560 to replace the gear, you need to:
1. Remove the power supply to access the gear set.
2. Remove any keeper rings or set screws holding the shaft.
3. Slide the shaft out carefully to free the gear.
4. Replace the gear.
5. Reinstall the shaft, aligning any flat spot on the shaft with the set screw.
6. Reattach the keeper ring to secure the shaft.
Synchronization may be needed after reassembly.
This answer is automatically generated
How do I thread the tension regulator? Singer Diana 560 (1979)
the feet on the feeder have seized..not moving at all