Do not blend more than 3 ice cubes
(approx. 60g) at a time.
Never blend dry ingredients (e.g.
spices, nuts) or run the Blender
Do not use the Blender as a storage
container whilst on the power unit.
Some liquids increase in volume and
froth during blending e.g. milk, so do
not overfill and ensure the blade
assembly is correctly fitted.
To ensure long life of your Blender,
never run it continuously for longer
than 45 seconds.
Never blend food that has formed a
solid mass during freezing, break it
up before adding to the bottle.
Never blend more than the
maximum capacity (600ml) marked
on the bottle.
When the dispensing lid is fitted
always keep the travel bottle upright.
care & cleaning
Always switch off, unplug and
dismantle before cleaning.
Never let the power unit, cord or
plug get wet.
Always wash immediately after use.
Do not let food dry onto the blade
assembly as this will make cleaning
Do not wash any part in the
Wipe with a damp cloth, then dry.
Unscrew the blade assembly from
the bottle. Then remove the blade
unit by pushing up from underneath.
Care should be taken when
removing the blade unit from
the blade assembly.
1 Remove and wash the sealing ring.
2 Do not touch the sharp blades -
brush them clean using hot soapy
water, then rinse thoroughly under
the tap. Do not immerse the blade
assembly in water.
3 Leave to dry upside down away from
bottle and dispensing lid
Wash the lid by hand, rinse with
clean water and dry.
service and customer
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
If you need help with:
using your appliance
servicing or repairs (in or out of
call Kenwood Customer Care on
023 9239 2333 or visit
your model number (e.g.
SMP06) and date code (5 digit
code e.g. 13L35) ready. They
are located on the underside of the
spares and attachments
call 0844 557 3653.
If you experience any problems with
the operation of your appliance,
before requesting assistance visit
Please note that your product is
covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
If your Kenwood product
malfunctions or you find any defects,
please send it or bring it to an
authorised KENWOOD Service
Centre. To find up to date details of
your nearest authorised KENWOOD
Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
Kenwood in the UK.
Made in China.