Omega 24 User Manual page 10

Do not touch a temperature probe sheath when measuring
excessively high or low temperatures, or toxic substances.
Do not attempt to measure temperatures beyond the range of
the probe being used. Probe damage or personal injury
could result from exceeding a probe's maximum temperature
rating.
The American National Safety Institute (ANSI) states that a
shock hazard exists when probes or sensors are exposed to
voltage levels greater than 42VDC or 42V peak AC. Do not
use this instrument where voltages at the measurement sur-
face exceed these levels.
Do not substitute a metal part for the nylon screw in the rear
case. Doing so will degrade electrical isolation of the case.
The battery is accessible through a cover on the back of the
instrument. To avoid electrical shock hazard, disconnect all
temperature probes and sensors and turn the unit off before
removing the cover.
Never use this instrument or any probe or sensor inside a
microwave oven.
Avoid making sharp bends in probe or sensor lead wires.
Bending lead wires at a sharp angle can damage the wire
causing probe failure.
8
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
CAUTION