Bosch 0 602 301 401 Original Instructions Manual page 46

OBJ_BUCH-698-001.book Page 46 Thursday, September 3, 2009 12:19 PM
46 | English
Assembly
Mounting the Protective Devices
General Information
Disconnect the power supply before mak-
ing any adjustments, changing accessories,
or placing the machine aside. This safety
measure prevents accidental starting of the
power tool.
Note: After breakage of the grinding disc during
operation or damage to the holding fixtures on
the protection guard/power tool, the machine
must promptly be sent to an after-sales service
agent for maintenance (for addresses, see sec-
tion „After-sales Service and Customer
Assistance".
Adjust protection guards in such a manner
that sparking toward the operator is pre-
vented.
Note: The encoding keys of the protection
guards ensure that only a protection guard that
fits the machine type can be mounted.
Protection Guard for Grinding (see figure A)
Applies for the following types:
– 0 602 304 40. – 0 602 324 464
– 0 602 324 434 – 0 602 324 474
– 0 602 324 44.
– Place the protection guard 6 with the encod-
ing key 8 engaging into the groove on the
spindle collar 4 until the shoulder of the pro-
tection guard is seated against the flange of
the power tool.
– Adapt the position of the protection guard to
the requirements of the work step.
– Secure the protection guard by tightening
locking screw 7 with a tightening torque of at
least 10 Nm.
3 609 929 B88 | (9/3/09)
Protection Guard with Quick Clamp
(see figure B)
Applies for the following types:
– 0 602 329 4.. – 0 602 334 4..
– 0 602 331 4.. – 0 602 335 4..
– 0 602 332 4..
– Release the clamping lever 10.
– Place the protection guard 11 with the en-
coding key 8 engaging into the groove on
spindle collar 4 until the shoulder of the pro-
tection guard is seated against the flange of
the power tool.
– Adapt the position of the protection guard to
the requirements of the work step.
– Lock the clamping lever 10.
The tightening tension of the clamp from the
protection guard 11 can be changed by loosen-
ing or tightening the adjustment screw 9. En-
sure that the protection guard 11 is tightly seat-
ed and check regularly.
Protection Guard for Cutting
Applies for the following types:
– 0 602 304 40. – 0 602 329 4..
– 0 602 324 434 – 0 602 331 4..
– 0 602 324 44. – 0 602 332 4..
– 0 602 324 464 – 0 602 334 4..
– 0 602 324 474 – 0 602 335 4..
For cutting metal, always use a protection
guard for cutting.
For cutting stone, always use a cutting
guide with dust extraction protection guard
(accessory).
The protection guards for cutting are mounted
analogue to the standard protection guards (see
figures A and B).
Bosch Power Tools