This also applies to the accompany- ing drawings and/or diagrams. Animo reserves the right to change parts at any time without giving prior or direct notification to the customer. The contents of this manual can also be changed without prior notification.
M-LINE Introduction Congratulations on your purchase and welcome to Animo! To fully benefit from the sup- port that Animo offers, register your product at www.animo.eu/warranty Models This manual covers the following coffee makers: ANIMO 1,85 2,1 / 2,2 2,4 Ltr...
M-LINE Safety instructions and danger warnings This appliance meets the mandatory safety regulations. Inexpert use can result in per- sonal injury and material damage. The following warnings and safety instructions must be observed before using the coffee maker. Instructions for use Read these instructions for use carefully, before using this appliance.
M-LINE • The plug must be taken out of the socket if the appliance has to be opened for cleaning or repairs. The manufacturer cannot be held liable for losses caused as a result of failure to observe these safety instructions. Safeguards The appliance is fitted with the following safeguards: Dry-boil protection (14) This appliance is equipped with a dry-boil protection. This protection triggers if the heating element overheats owing to a fault.
Page 11
M-LINE Appliances and the environment The packing material Your new coffee maker has been carefully packaged to protect it against damage. The packing is not harmful to the environment and consists of the following materials: • Corrugated cardboard • Filler elements made of polyurethane foam <PUR> covered with a polythene film (>PE-HD<). The waste processing plant in your municipality will be pleased to inform you about where you can dispose of the materials.
M-LINE 1. GENERAL A quick look at the appliance The most important parts of the appliance are shown in the fold-out sheet in this manual. Keep the fold-out sheet open when reading the instructions. 1.1.1 Most important parts 1. Appliance on/off switch coffee making Water reservoir opening section and bottom hot plate Glass jug/thermos flask...
M-LINE Installation CAUTION • Water always remains in the heating system: for this reason the appliance must not be placed in an area where the temperature can fall below freezing point. 3.2.1 Preparation for positioning the appliance Position the appliance at buffet height on a firm, level base that can bear the weight of the appliance when it is filled.
M-LINE 6. Switch on the appliance by setting the on/off switch (1) to the I positio. The indicator lights (5.1 and 5.2) will light up and an audible signal will sound. The green indicator light (5.2) will now light up until the appliance has finished making the coffee.
M-LINE 3.2.6 Setting the descale indicator Scale deposits are left in the heating system when the appliance is used. The amount of scaling depends on the hardness of the water being used. The coffee maker is fitted with a descale indicator light (5.1), which lights up when the heating system has processed a certain quantity of water and has to be descaled.
M-LINE 4. DAILY USE NOTICE • The leak stop can only work if the jug detector is pressed in sufficiently by the jug. If you use a coffee jug with a narrow neck the jug detector will not be pressed in sufficiently and the appliance will not start. When using the appliance you may find that certain settings do not entirely match your requirements.
M-LINE Making coffee 1. Place a sheet of basket filter paper containing the desired amount of coffee (fine grind type) in the basket filter. See the table above for the amount of coffee required. 2. Slide the basket filter (1) into the appliance. 3.
M-LINE 5. SETTINGS NOTICE • The prewet function can only be activated when the descale indicator light (5.1) does not lights. When the descale indicator light (5.1) lights first descale the coffee system, see chapter 6.2 Descaling. After descaling reset the descale indicator light, see chapter 6.2.1 Switching-off the descale indicator light.
The thermos jug, thermos jug with pump and the filter can be rinsed with hot water. The coffee deposit in the coffee jugs and the filter can be cleaned with Animo coffee fur remover. The appliance is supplied with one sachet of coffee fur remover.
1. Before descaling the appliance, carefully read the instructions for use on the scale remover. We advise you to use the tried and tested Animo scale remover. 2. Dissolve one 50 gram sachet of Animo scale remover in 1 litre of warm water (approx. 60-70˚C).
M-LINE 7. TROUBLESHOOTING WARNING • Have all repairs to the electrical system performed by a qualified service technician. If your appliance is not functioning correctly, use the troubleshooting guide below to see whether you can resolve the problem yourself. If not, please contact your dealer. Troubleshooting guide coffee making selection Symptom: Possible cause: Action: The appliance is not work- The fuse in the fuse box...
Page 23
M-LINE Troubleshooting guide coffee making selection Symptom: Possible cause: Action: Coffee is dripping out of the The leak stop valve on the Clean the filter and check filter when there is no jug outlet of the filter is soiled the leak stop valve for under it.
M-LINE 8. CONSUMER ARTICLES AND ACCESSORIES See the list below for the consumer articles and accessories available for the appliance. You can order these parts via your dealer, stating the details of the appliance given on the type plate, a description of the item, article number and quantity. Consumer articles Description Art.No.
Page 25
Animo B.V. Dr. A. f. Philipsweg 47 P.O. Box 71 9400 AB Assen The Netherlands Tel: +31 (0) 592 376376 fax: +31 (0) 592 341751 E-mail: info@animo.nl www.animo.eu 2015/02 Rev. 4.0 09825...
Need help?
Do you have a question about the M-SERIES and is the answer not in the manual?
Questions and answers