Table of Contents
Advertisement
User manual
Chapter IV Voice alarm receiving
4.1 Remote phone control
User can remote control the system by phone call, after the preset ringing
times then panel will off hook the phone then enter the 4 digit user codes
according to voice prompting and operate as per the voice prompting.
User call landline
phones
Then enter user code according
to voice prompting( the factory
default user code is 1234)
4.2 Alarm receiving phone operation
When alram, the panel will dial the pre-set voice phone number, when the
user pick up the call, they will hear the voice prompting as below, if not press 1
to cancel the alarm or press 4 to disarm the system, after off-hook, the panel
will call other preset voice phone numbers .
The panel will dial
the preset voice
phone number
when alarm occurs
and GSM control
The phone rings is 7
times, after 7 times ring,
the panel will off-hook
automatically.
1
2
3
4
1
The user pick up
the call
Telephone line
Press 1 to arm system
Press 2 to disarm system
Press 3 to Stay arm
Press 4 to check system status
Press 5 to appliance switch control
Press 6 to control programmable
Press 0 to Disconnect
Play the recorded voice message
first, then :
2
Press 1 to cancel alarm
Press 2 to check alarm event
Press 3 to arm system
Press 4 to disarm system
Press 5 to Stay arm
Press 6 to enable siren
Press 7 to listen-in
Press 8 to control programmable
output port
Press 0 to Disconnect
Please enter
password
output port
3
11
Hide quick links:
Advertisement
Table of Contents
