Omega OMB-DAQBOARD-3000 Series User Manual page 94

In general, the following terminal block-to-signal relationships apply:
DBK215 Used for . . .
Terminal
Blocks
TB9 ANALOG INPUT
TB10
TB11 ANALOG INPUT
TB12
TB5 DIGITAL I/O
TB6
TB7
TB8
TB13** ANALOG INPUT
TB14** BNC Channels
0 thru 7**
TB15 USER
TB16 CONFIGURABLEB
(Note 1) NC Channels
A thru H
TB1 -- Not Used---
TB2
TB3 PULSE/
TB4 FREQUENCY
ANALOG OUTPUT
*
P4 is used for connecting to DaqBoard/2000 Series devices.
**
TB13 and TB14 are "virtual" terminal blocks which are routed in the printed circuit board to TB9 and TB10. The TB13 and TB14
silk-screened locations on the DBK215 board do not have physical screw terminal blocks.
Note 1:
TB15 and TB16 are used for optional user-configured BNC connectors A through H. These connectors can be configured
on a per-channel basis as Analog [Input or Output], Digital I/O, or Counter/Timer. When BNC A through H are used, the
user must route wires from the "BNC routing terminal blocks" (TB15 and TB16) to the appropriate functional TB
termination points.
Accessory Wire Kit, p/n 1139-0800 includes jumper wires and a screwdriver.
The following pages correlate the DBK215 terminal block connectors with the 68-pin SCSI connector.
DBK215, pg. A-6
Alternative
BNC 0 thru 7
N/A
N/A
TB9,TB10
(See Note 1)
N/A
N/A
948894
DBK215 Board
Appendix A