Omega OMB-DAQBOARD-3000 Series User Manual page 13

Step 4
– Test Hardware
Use the following steps to test the DaqBoard. Note that these steps are continued from those listed under the previous
section, "Configure Board."
1. Select the "Test Hardware" tab.
2. Click the "Resource Test" button.
3. After the test is complete, click "OK."
System capability is now tested for the DaqBoard and a
list of test results appears on screen.
Note: If you experience difficulties, please consult your
user documentation (included on your CD) before calling
for technical support. Note that the user documentation
includes a troubleshooting chapter, as well as a great deal
of information regarding specific DBK cards and modules,
which can be used with DaqBoard/2000 systems. DBK
options are not used with DaqBoard/3000 Series boards.
At this point we are ready to connect signals.
1033-0940, rev 8.0
•
For DaqBoard/3000 Series boards, connection is typically made via a terminal board, such as
the optional TB-100, a DBK215 module via a 68-pin SCSI connector and/or a PDQ30 via a
HDMI connector. However, note that the DaqBoard/3006 has no HDMI connector and cannot
be connected to a PDQ30.
•
For DaqBoard/2000 Series boards, signal connection is typically accomplished with the use
of a DBK200 Series option.
Reference Notes:
DaqBoard/2000 Series users: For detailed information regarding the DBK200 Series
options, refer to the DBK Option Cards and Modules User's Manual (p/n 457-0905).
During software installation, Adobe
installed onto your hard drive as a part of product support. The default location is in the
Programs group, which can be accessed from the Windows Desktop. A copy of the Adobe
®
Acrobat Reader is included on your CD. The Reader provides a means of reading and
printing the PDF documents. Note that hardcopy versions of manuals can be ordered from
the factory.
918494
Test Hardware Tab
(Condensed Screen Image)
®
PDF versions of user manuals are automatically
DaqBoard Installation Guide IG-7