Omega OMB-DAQBOARD-3000 Series User Manual page 11

7. Refer to the figure at the right. Align the groove in the
DaqBoard's PCI edge-connector with the ridge of the
desired PCI slot, and with the PC's corresponding rear-
panel slot.
8. Push the board firmly into the PCI slot. The board will
snap into position.
9. Secure the board by inserting the rear-panel adapter-plate
screw.
10. Using the previous steps, install additional boards into
available PCI bus-slots, if applicable to your application.
11. Replace the computer's cover.
12. Plug in all cords and cables that were removed in step 1.
13. Apply power to, and start up the PC.
Note: At this point some PCs may prompt you to insert an
installation disk. While this is rare, if you do receive such a
prompt simply place the install CD-ROM into the disk drive
and follow additional screen prompts.
Step 3
– Configure Boards
DaqBoard/2000 and /3000 Series Boards have no jumpers or switches to set. Configuration is
performed, in its entirety, through software. Refer to the following figure and steps to complete the
configuration.
The numbers in the figures correspond to the numbered steps which immediately follow.
1033-0940, rev 8.0
Accessing the DaqBoard/2000 Properties Tab
Images are similar for DaqBoard/3000 Series boards.
918494
Installing a DaqBoard/2000 Series Board
DaqBoard Installation Guide IG-5