Omega OMB-DAQBOARD-3000 Series User Manual page 44

P1
(37-pin)
P4
(100-pin)
P5 SCSI
(68-pin)
** CA-G56 is a 3 ft. shielded cable; CA-G55, a 3 ft. unshielded cable; CA-G56-6, a 6 ft. shielded cable.
pg. iv_DaqCal
For DB37 P1 applications you can attach a DBK11A to the device via a CA-37 cable.
For 100-pin P4 connector applications you can use a DBK200 (or DBK201), DBK11A, and
a CA-195 cable; or you could use a DBK213 and a CA-195 cable. Illustrations of these two
scenarios follow.
Connecting a DBK11A via a DBK200
* There are several DBK200 Series adaptive boards and modules available for 100-pin P4
connector applications. Refer to your hardware documentation or DBK Options Manual
for specific information. PDF versions of documents are included on the data acquisition
CD and on our web site.
For 68-pin SCSI (P5) connector applications you can use a CA-G56 cable to attach a
passive TB-100 screw-terminal connector option. CA-G55 or CA-G56-6 can be substituted
for the CA-G56 cable.**
Note that in place of the TB-100, a DBK215 Module could be used. Refer to your hardware
documentation or DBK Options Manual for specific information. PDF versions of
documents are included on the data acquisition CD and on our web site.
918494
Connecting a DBK11A
Connecting a DBK213
Connecting a TB-100
User Calibration Guide, 457-0931 rev 1.0