Connections - Omega OMB-DAQBOARD-3000 Series User Manual

Connections

SCSI - 68 pin
HDMI
1-2 Daq Systems and Device Overviews
Block Diagram for DaqBoard/3005 and /3006
* Note: DaqBoard/3006 has 16 single-ended analog inputs; ±10V input range only;
it has no differential input. DaqBoard/3006 has no HDMI interface.
Reference Note:
For the DaqBoard/3000 Series installation procedure, refer to the DaqBoard Installation
Guide (1033-0940). A copy of the guide is included at the beginning of this manual.
All input and output signals are available at the 3000 Series board's 68-pin SCSI
connector. Chapter 2 includes a pinout. A TB-100 screw-terminal board or a DBK215
BNC / screw-terminal module can be used to make all signal I/O connections. Either of
these two termination options can be connected to the DaqBoard/3000 Series SCSI
connector via one of the following cables.
CA-G55 68-conductor ribbon expansion cable. 3 feet.
CA-G56 68-conductor shielded expansion cable. 3 feet.
CA-G56-6 68-conductor shielded expansion cable. 6 feet.
The HDMI connector can be used to connect a PDQ30 analog expansion module
to a DaqBoard/3000 Series board. Details are provided in Chapter 2 of this manual.
Cable CA-266-3 (3 ft.) [or CA-266-6 (6 ft.)] is used to connect the PDQ30 to the 3000
Series board.
The HDMI connector is not present on DaqBoard/3006.
988093
DaqBoard/3000 Series User's Manual