Omega OMB-DAQBOARD-3000 Series User Manual page 12

1. Run the Daq Configuration control panel applet. Navigation from the desktop to the applet is as follows:
Start ⇒ Settings ⇒ Control Panel ⇒ Daq*Configuration (double-click)
2. Double-click on the Device Inventory's DaqBoard1K0, 2K0, or 3K0 icon, as applicable. The DaqBoard's
Properties tab will appear. If the DaqBoard icon is not present, skip to the upcoming Using 'Add Device'
section.
3. Enter a "Device Name" in the text box, or use the default, e.g., DaqBoard2K0. The Name is for identifying the
specific DaqBoard, but actually refers to the PCI slot.
4. Verify that the "Device Type" shows the correct board, e.g., "DaqBoard/2000, DaqBoard/2001, etc."
Note that available device types can be viewed via the pull-down list.
5. Confirm that the DaqBoard's text box shows a Bus #, Slot #, and Serial Number.
If this text box is empty, use its pull-down list and select the serial number that matches the one for your board.
Using "Add Device"
This method is for users who have accessed the Daq
Configuration control panel applet, but have no DaqBoard1K,
2K, or 3K [as described on page IG-5, step 2].
(A) After accessing the Daq Configuration control panel applet,
click on the <Add Device> button (see figure, right). The
Select Device Type window will appear.
(B) Using the Device Type's pull-down list, select the applicable
board. In the example at the right DaqBoard/2000 is
selected.
(C) Click the <OK> button. The board's Properties tab will
appear.
Note that this tab will apply to all boards in the series.
At this point, complete steps 3 through 5 from page IG-5.
DaqBoard Installation Guide
IG-6
918494
Using "Add Device"
1033-0940, rev 8.0