Remove The Fan Cage - HP Proliant ML350p Gen8 User Manual

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 19).
o
Power down the server (on page 18).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 22).
o
Remove the access panel (on page 21).
o
Locate the fan to be removed.
5.
Remove the fan.
6.

Remove the fan cage

IMPORTANT: When installing or replacing server components, one or more fans might need
to be removed. To prevent an orderly or immediate server shutdown, Hewlett Packard
Enterprise highly recommends powering down the server during these procedures. To
determine if powering down is required, see the specific procedure.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 19).
o
Power down the server (on page 18).
2.
Remove all power:
3.
("Remove the tower bezel" on page 19).
("Remove the tower bezel" on page 19).
Operations 25