HP Proliant ML350p Gen8 User Manual page 100

Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 19).
o
Power down the server (on page 18).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 22).
o
Remove the access panel (on page 21).
5.
Remove the air baffle (on page 23).
6.
If installed, remove the PCI card from slot 9
7.
CAUTION: Any attempt to remove an installed TPM from the system board breaks or
disfigures the TPM security rivet. Upon locating a broken or disfigured rivet on an installed
TPM, administrators should consider the system compromised and take appropriate measures
to ensure the integrity of the system data.
Install the TPM board. Press down on the connector to seat the board
8.
on page 10).
("Remove the tower
("System board components" on page 10).
Hardware options installation 100
bezel" on page 19).
("System board components"