Christie LX505 Quick Reference Manualninja250L page 5

All the safety and operating instructions should
be read before the product is operated.
Read all of the instructions given here and
retain them for later use. Unplug this projector
from AC power supply before cleaning. Do not
use liquid or aerosol cleaners. Use a damp
cloth for cleaning.
Follow all warnings and instructions marked on
the projector.
For added protection to the projector during a
lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet. This will prevent damage
due to lightning and power line surges.
Do not expose this unit to rain or use near
water... for example, in a wet basement, near a
swimming pool, etc...
Do not use attachments not recommended by
the manufacturer as they may cause hazards.
Do not place this projector on an unstable cart,
stand, or table. The projector may fall, causing
serious injury to a child or adult, and serious
damage to the projector. Use only with a cart
or stand recommended by the manufacturer, or
sold with the projector. Wall or shelf mounting
should follow the manufacturer's instructions,
and should use a mounting kit approved by the
manufacturers.
An appliance and cart
combination should be
moved with care. Quick
stops, excessive force, and
uneven surfaces may cause
the appliance and cart
combination to overturn.
Slots and openings in the back and bottom
of the cabinet are provided for ventilation, to
ensure reliable operation of the equipment and
to protect it from overheating.
The openings should never be covered with
cloth or other materials, and the bottom
opening should not be blocked by placing the
projector on a bed, sofa, rug, or other similar
surface. This projector should never be placed
near or over a radiator or heat register.
This projector should not be placed in a built-in
installation such as a book case unless proper
ventilation is provided.
Never push objects of any kind into this
projector through cabinet slots as they may
touch dangerous voltage points or short out
parts that could result in a fire or electric shock.
Never spill liquid of any kind on the projector.
Setup Guide
Downloaded From projector-manual.com Christie Manuals
020-000540-01 Rev. 1 (11-2010)
Do not install the projector near the ventilation
duct of air-conditioning equipment.
This projector should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supplied, consult your authorized dealer or
local power company.
Do not overload wall outlets and extension
cords as this can result in fire or electric shock.
Do not allow anything to rest on the power
cord. Do not locate this projector where the
cord may be damaged by persons walking on
it.
Do not attempt to service this projector
yourself as opening or removing covers may
expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service
personnel.
Unplug this projector from wall outlet and refer
servicing to qualified service personnel under
the following conditions:
a. When the power cord or plug is damaged or
frayed.
b. If liquid has been spilled into the
projector.
c. If the projector has been exposed to rain
or water.
d. If the projector does not operate normally
by following the operating instructions.
Adjust only those controls that are covered
by the operating instructions as improper
adjustment of other controls may result in
damage and will often require extensive
work by a qualified technician to restore the
projector to normal operation.
e. If the projector has been dropped or the
cabinet has been damaged.
f. When the projector exhibits a distinct
change in performance- this indicates a
need for service.
When replacement parts are required, be sure
the service technician has used replacement
parts specified by the manufacturer that have
the same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, or injury to persons.
Upon completion of any service or repairs to
this projector, ask the service technician to
perform routine safety checks to determine that
the projector is in safe operating condition.
3
LX505/605