Table of Contents
Advertisement
Intelligent Surveillance Solution
Hardware Installation
Step1:
Insert the card onto an empty PCI-e slot. Connect the Audio/Video
Cable to the connector.
Note 1: The audio input connectors are with red wires and marked of "A"
on them (such as "A1/9"); the video input connectors are with black wires
and marked of "V" (such as "V8/16").
Note 2: You need to power down the PC before you insert the card.
Step 2:
Connect the Watchdog wire to the reset connector on the main
board.
Note: With the Watchdog Wire connected, the system will be restarted if
any abnormal conditions.
Step 3:
Turn on your PC and start Windows.
Step 3:
Insert the included Software CD into CD-ROM.
Step 4:
Refer the section Driver Installation on page 18 to install driver.
Step 5:
After driver is installed, restart your PC.
Optional I/O Card:
Step 1:
Fix the IO card onto your PC.
Step 2:
Connect the Capture Card and the I/O Card with an included
ribbon cable (2.00mm IDC cable).
Note 1: The default configuration of blue slide switch on I/O Card as
below.
Note 2: If you only use one I/O card to connect with one of 6000S/7000S
cards, please make sure the configuration of the black slide switch as
below.
Maximum optional I/O Card support:
6000S/7000S can support maximum 4 I/O cards. Please refer to figures on
the following pages.
page - 4
refer to the figures on the following pages.
Advertisement
Table of Contents
