Maintenance - Senco SFT10XP Operating Instructions Manual

tool uSE
automatiC toolS oNly
y y
This tool is equipped with a drive
rate adjustment to adjust the
speed.
y y
Rotate the screw, not more than
three turns, counter-clockwise
( Q ) to increase the drive rate.
Rotate the screw clockwise (
not more than three turns, to
slow the drive rate.
y y
For single shot operation, pull
trigger only partially. For auto-
matic operation, pull trigger fully.

maiNtENaNCE

WaRNiNg
y y
Repairs other than those
described here should be per-
formed only by trained,
qualified personnel.
y y
Read section titled "Safety
Warnings" before maintaining
tool.
y y
All screws should be kept tight.
Loose screws result in unsafe
operation and parts breakage.
y y
With tool disconnected, make
daily inspection to assure free
movement of trigger. Do not use
tool if trigger sticks or binds.
y y
Squirt Senco pneumatic oil (5 to
10 drops) into the air inlet daily
(depending on frequency of tool
use). Other oils may damage
O-rings and other tool parts.
y y
Wipe tool clean daily and
inspect for wear. Use non-flam-
mable cleaning solutions only if
necessary.
y y
DO NOT SOAK.
y y
Caution: Such solutions may
damage O–rings and other tool
parts.
P ),
9