Senco SFT10XP Operating Instructions Manual page 4

SaFEty WaRNiNgS
y y
Drive fasteners into work surface
only; never into materials too
hard to penetrate.
y y
Do not drive fasteners on top of
other fasteners or with the tool
at too steep of an angle; the
fasteners can ricochet and hurt
someone.
y y
Do not drive fasteners close to
the edge of the work surface.
The workpiece is likely to split
and the fastener could fly free or
ricochet and hit someone.
y y
Tool may eject a fastener when
connected to air supply; there-
fore, remove all fasteners from
tool before connecting air.
y y
Never use tool if trigger or
springs have become inopera-
ble, missing or damaged. Do not
tamper with or remove trigger or
springs.
y y
Disconnect tool from air before
doing tool maintenance, clearing
a jammed fastener, leaving work
area, moving tool to another
location, or handing the tool to
another person.
4