Run Test
With this menu you are able to test the device.
1) Press Menu, until the display shows: Runmode.
2) Press Enter and use the Up/Down buttons to go to the Run menu.
3) Press Enter to open this menu. Scroll through the menu until the display shows TEST.
4) When you press ENTER, the display will blink once and the device will start an internal test.
Slave Mode
With this menu you are able to set the device as a slave device.
1) Press Menu, until the display shows: Runmode.
2) Press Enter and use the Up/Down buttons to go to the Run menu.
3) Press Enter to open this menu. Scroll through the menu until the display shows Slave.
4) When you press ENTER, the display will blink once and the device will be in slave mode.
4.2 Edit
Once you have entered a step you will see menu 4.2.2 - 4.2.11 (Pan - Use)
1) Press Menu, until the display shows: Runmode.
2) Press Enter and use the Up/Down buttons to go to the Edit menu.
3) Press Enter and use the Up/Down buttons to scroll through the options: Step, Pan, Tilt, Red, Green, Blue,
White, Dimmer, Strobe, Time, Use.
4) Press Enter to select one of these options. Use the Up / Down buttons to set the desired setting.
5) Once you have set the desired mode, press the enter button to store your setting.
Note: If you want to circulate the created steps, please set the last step as 0.
For example, when you have 3 steps, the setting should be:
Step 1 Time = 4
Step 2 Time = 5
Step 3 Time = 0
Use = Yes
Use = Yes
Use = Yes
21