Installing Flash Support Files For Fps-8 And Fps-10 - Nokia N72 Service Manual

RM-180
Service Software Instructions
iv For a plain USB connection, choose the following connection settings:
Note: First connect the DKU-2 USB cable between the PC USB port and phone.
• Media: USB
5. To complete the configuration, click Finish.
6. Click the connection you want to activate. Use the up/down arrows located on the right hand side to move
it on top of the list, then click Apply.
The connection is activated, and it can be used after closing the
The connection information is shown at the right hand bottom corner of the screen.
7. To use the connection, connect the phone to your PC with correct service tools. Make sure the phone is
switched on, and then choose File→Scan Product .
Results
The product support module information appears in the status bar:

Installing flash support files for FPS-8 and FPS-10

Prerequisites
Phoenix service software.
• Install
• Install phone model specific data package for
• If you want to update the flash support files, they are delivered in the same installation package with
Phoenix or newer Phoenix packages beginning from December 2004.
In case you want to update the MCU files, install the latest data package (see Technical Bulletins for
information on the latest one).
Normally, it is enough to install
always includes the latest flash update package files for FPS-8 and FPS-10.
• A separate installation package for flash support files is available. The files can be updated according to
these instructions, if updates appear between
Issue 1
Figure 19 Connections list
Figure 20 Connection information
Figure 21 Product support module information (example from RM-1)
Phoenix and the phone-specific data package because the installation
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
Manage Connection window.
Phoenix .
Phoenix data package releases.
Nokia Customer Care
Page 3 –19