Installing Flash Support Files For Fps-8 And Fps-10 - Nokia RM-70 Service Manual

Nokia Customer Care
iv For a plain USB connection, choose the following connection settings:
Note:
• Media: USB
5. To complete the configuration, click Finish.
6. Click the connection you want to activate. Use the up/down arrows located on the right hand side to move
it on top of the list, then click Apply.
The connection is activated, and it can be used after closing the
The connection information is shown at the right hand bottom corner of the screen.
7. To use the connection, connect the phone to your PC with correct service tools. Make sure the phone is
switched on, and then choose File→Scan Product .
Results
The product support module information appears in the status bar:
Figure 23 Product support module information (example from RM-1)

Installing flash support files for FPS-8 and FPS-10

Before you begin
Phoenix service software.
• Install
• Install phone model specific data package for
• If you want to update the flash support files, they are delivered in the same installation package with
Phoenix or newer Phoenix packages beginning from December 2004.
In case you want to update the MCU files, install the latest data package (see Technical Bulletins for
information on the latest one).
Normally, it is enough to install
always includes the latest flash update package files for FPS-8 and FPS-10.
• A separate installation package for flash support files is available. The files can be updated according to
these instructions, if updates appear between
Page 3 –20
First connect the DKU-2 USB cable between the PC USB port and phone.
Figure 21 Connections list
Figure 22 Connection information
Phoenix and the phone-specific data package because the installation
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
Manage Connection window.
Phoenix .
Phoenix data package releases.
Service Software Instructions
RM-70
Issue 1