Installing Phoenix - Nokia N72 Service Manual

Nokia Customer Care
If you use FPS-10:
Results
Phoenix is ready to be used with FPS-8 or FPS-10 flash prommers and other service tools.
Phoenix
Installing
Prerequisites
• Check that a dongle is attached to the parallel port of your computer.
Phoenix installation package (for example, phoenix_service_sw_2004_39_x_xx.exe ) to your
• Download the
C:\TEMP , for instance).
computer (in
• Close all other programs.
• Depending on your operating system, administrator rights may be required to install
• If uninstalling or rebooting is needed at any point, you will be prompted by the InstallShield program.
Context
At some point during the installation procedure, you may get the following message:
This may be a result of a defective or too old PKD-1 dongle.
Check the COM/parallel ports used. After correcting the problem, you can restart the installation.
For more detailed information, please refer to
Tip: Each feature in
program. Press the F1 key or the feature's Help button to activate a Help file.
Steps
1. To start the installation, run the application file (for example,
Welcome dialogue, click Next.
2. In the
Page 3 –6
Figure 4 Dongle not found
Phoenix Help files.
Phoenix has its own Help function, which can be activated while running the
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
• Update FPS-10 software
Note: There is no need to activate FPS-10.
• Activate SX-4 smart card, if you need tuning and
testing functions.
Note: When FPS-10 is used only for
product software updates, SX-4 smart
card is not needed.
phoenix_service_sw_2004_39_x_xx.exe ).
Service Software Instructions
Phoenix .
RM-180
Issue 1