Mounting The Switch On The Wall; Mounting On A Cement Wall; Mounting On A Wood Wall - D-Link DGS-2208 User Manual

Section 3 - Installation
The DGS-2208 can also be mounted on a wall. Two mounting slots are provided on the bottom of the switch for this
purpose. Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration
below:
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back on the screws.
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back on the screws.
D-Link DGS-2208 User Manual

Mounting the Switch on the Wall

Mounting on a cement wall

Mounting on a wood wall

(1) 3/4 inch minimum for wood wall
(2) 3 inch minimum for cement wall.
16