set-metric-type type1
Step 7
Apply Route Policy to RIP Out-Policy
ip rip interface
20.1.1.2 out-policy
"Rip_Dist"
Step 8
Configure OSPF route distribution to distribute RIP routes as AS-external-LSA Type 1
config ip ospf redistribute rip create
config ip ospf redistribute rip metric-
type type1
config ip ospf redistribute rip enable
9. Configuration Examples
9.1
OSPF Route Distribution to RIP, RIP to OSPF
(AS-external-LSA Type 1 Metrics)
To configure a Ethernet Routing Switch 8600 as an OSPF ASBR and distribute all OSPF routes to RIP
and RIP to OSPF, perform the following steps:
Step 1
Configure RIP Interface
config ethernet 1/31 ip create
10.1.1.41/30 2136
config ethernet 1/31 ip rip enable
config ip rip enable
config ip rip interface 10.1.1.41 send-
mode rip2
config ip rip interface 10.1.1.41 receive-
mode rip2
Step 2
Configure OSPF Interface
config ethernet 2/7 ip create 10.1.1.2/30
2134
config ethernet 2/7 ip ospf enable
November 2010
Figure 10: OSPF ASBR Configuration Example
ERS 8600 / 8800 OSPF Technical Configuration Guide
These two commands configure port 1/31 as a brouter
port and enables RIP on this interface
These commands enable RIP and configures the RIP
interface for RIPv2 mode only.
These two commands configure port 2/7 as a brouter
port and enables OSPF on this interface
avaya.com
27