Ospf Asbr Cli - Avaya 8600 Engineering

avaya.com
config ip route-policy "Rip_Dist" seq 1 set-metric-type type1
ip rip interface 20.1.1.2 out-policy "Rip_Dist"
config ip ospf redistribute rip create
config ip ospf redistribute rip metric-type type1
config ip ospf redistribute rip enable
10.8

OSPF ASBR CLI

Reference Figure 10 (page 20) and the configuration tables on pages 20-21:
Ethernet Routing Switch 8600C Configuration:
config ethernet 1/31 ip create 10.1.1.41/30 2136
config ethernet 1/31 ip rip enable
config ip rip enable
config ip rip interface 10.1.1.41 send-mode rip2
config ip rip interface 10.1.1.41 receive-mode rip2
config ethernet 2/7 ip create 10.1.1.2/30 2134
config ethernet 2/7 ip ospf enable
config ip circuitless-ip-int 1 create 1.1.1.3/32
config ip circuitless-ip-int 1 ospf enable
config ip ospf as-boundary-router enable
config ip ospf router-id 1.1.1.3
config ip ospf enable
config ip ospf redistribute rip create
config ip ospf redistribute rip metric 10
config ip ospf redistribute rip metric-type type1
config ip ospf redistribute rip enable
config ip route-policy "Allow" seq 1 create
config ip route-policy "Allow" seq 1 enable
config ip route-policy "Allow" seq 1 action permit
config ip route-policy "Allow" seq 1 match-protocol local|ospf
config ip rip interface 10.1.1.41 out-policy "Allow"
To configure the Ethernet Routing Switch 8600 ASBR to distribute only a default route instead of
all OSPF routes to RIP:
config ip prefix-list "default" add-prefix 0.0.0.0/0
config ip route-policy "Policy_Default" seq 1 create
config ip route-policy "Policy_Default" seq 1 enable
config ip route-policy "Policy_Default" seq 1 action permit
config ip route-policy "Policy_Default" seq 1 match-protocol ospf
ERS 8600 / 8800 OSPF Technical Configuration Guide
48
November 2010