Hoveround mpv5 Owner's Manual And Warranty page 25

4. Plug the AC power cord into the back of the charger.
5. Plug the other end of the AC power cord into a 120-volt grounded
household power outlet.
6. Follow the specific instructions for your charger. Charger instructions
begin on page 24.
7. When the batteries are charged, and/or you are ready to use
the chair:
A. If your charger is equipped with an off button,
turn OFF the power switch on your charger.
B. Unplug the charger from the household power outlet.
C. Unplug the charger from the joystick controller.
If you have a:
Flying Power FY-4101 Charger
1. Switch the power on. A light will illuminate on the output side of the
charger, indicating power is available. If the light does not go on,
please check to make sure the household power is working.
2. If the light is red, the batteries are charging.
3. When the light is green, the batteries are charged.
4. If the batteries do not appear to be fully charged and the green light
is on, check to make sure the charger has been properly plugged
into the controller charging port and the batteries are connected.
UPG 24BC5000TF-1 AGM sealed lead acid Charger
1. Switch the power on. Two red lights will illuminate on the output
side of the charger indicating the power is on, the charger is in the
charge mode and the cable is fully plugged into the controller.
If one red light and one green light are illuminated or if only one
red light is on, check to make sure the charger is plugged fully into
the controller. If no lights are on, please check to make sure the
household power is working.
2. When two red lights are on, the batteries are being charged.
3. When one red and one green light is on AND the cord is fully
plugged into the controller, the batteries are charged.
D82008753R 10/15 Chapter 2 25