Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
REVO-1, REVO-3, REVO-4
CONGRATULATIONS on your choice of a Crimestopper Revo Start 1-Way Remote Start System. This system is
an RF Antenna Decoder that plugs directly into a Fortin or ADS Data module. No additional remote start module is
needed. The features of the system, depends on the vehicle and data module used. This system requires a Fortin
or ADS data module with a programmer to load correct vehicle software. You will need the vehicle install guide from
Fortin or ADS iDatalink website. Many vehicles have a "Plug n Play" T harness available to simplify the installation.
The remotes need to be programmed after installation of data module before operation. If any questions arise,
contact your installation dealer or Crimestopper Security Products Inc.
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV 09-2013
1 - Way Remote Start System
INSTRUCTIONS
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation.
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
The manufacturer is not
Advertisement
Related Manuals for CrimeStopper revo-1
Summary of Contents for CrimeStopper revo-1
- Page 1 1 - Way Remote Start System INSTRUCTIONS CONGRATULATIONS on your choice of a Crimestopper Revo Start 1-Way Remote Start System. This system is an RF Antenna Decoder that plugs directly into a Fortin or ADS Data module. No additional remote start module is needed.
-
Page 2: Using The Remote Transmitter
REVO-1 REVO-3 REVO-4 AUX 1 = Trunk + Lock AUX 2 = Trunk + Unlock For REVO-1 AUX 3 = Trunk + Start The transmitter supplied has one Start button. AUX 4 = Lock + Start For REVO-3 The transmitter supplied with this system has 4 vertical buttons – Lock, Unlock, Vehicle Select and Start. -
Page 3: Battery Replacement
BATTERY REPLACEMENT To replace the battery on 1 button remote: Simply remove the screw on back of the transmitter and slide the case apart as shown. Remove the two CR-1620 Lithium batteries and replace. Put case back together and tighten screw. - Page 4 BATTERY REPLACEMENT To Replace the Battery on 3 and 4 button remote: The Remote Control uses two CR-2025 Lithium 3 Volt Batteries. Simply remove the Phillips screw located behind key ring (see diagram below). Use a small screw driver as shown in Figure 2 to remove the back cover. Slide old batteries out.
-
Page 5: Vehicle Operation
2 VEHICLE OPERATION A single Remote Control can control two different vehicles. To set up the 2-Vehicle operation you must first program your remotes to Vehicle #2. Follow the “Transmitter Programming” steps (Pg. 6) at the second vehicle and learn YOUR remote, along with vehicle #2’s existing remotes. -
Page 6: Transmitter Programming
TRANSMITTER PROGRAMMING Note: Programming of Data Module to vehicle must be completed FIRST! The system learns up to 4 different transmitter codes. There are 2 methods of programming remotes depending on the Data module used to operate your vehicle. ADS iDatalink Programming: 1. - Page 8 Phone (800) 998-6880 FAX (805) 581-9500 © 2013 Crimestopper Security Products...