Advanced Pci/Pnp Settings - Advantech SOM-5787 User Manual

USB Mass Storage Reset Delay
Number of seconds when POST wait for the USB mass storage device after
start unit command.
Emulation Type
If Auto, USB devices less than 530MB will be emulated as Floppy and remaining
as hard drive. Force FDD option can be used to force a FDD formatted drive to
boot as FDD (Ex. ZIP drive).
3.4

Advanced PCI/PnP Settings

Select the PCI/PnP tab from the SOM-5787/6787 setup screen to enter the Plug and
Play BIOS Setup screen. You can display a Plug and Play BIOS Setup option by
highlighting it using the <Arrow> keys. All Plug and Play BIOS Setup options are
described in this section. The Plug and Play BIOS Setup screen is shown below.
Clear NVRAM
Set this value to force the BIOS to clear the Non-Volatile Random Access Mem-
ory (NVRAM).The Optimal and Fail-Safe default setting is No.
Plug & Play O/S
When set to No, BIOS configures all the device in the system. When set to Yes
and if you install a Plug and Play operating system, the operating system config-
ures the Plug and Play device not required for boot.
PCI Latency Timer
Value in units of PCI clocks for PCI device latency timer register.
Allocate IRQ to PCI VGA
When set to Yes, it will assign IRQ to PCI VGA card if card requests IRQ. When
set to No, it will not assign IRQ to PCI VGA card even if card requests an IRQ.
Palette Snooping
This item is designed to solve problems caused by some non-standard VGA
card.
SOM-5787/6787 User Manual
Figure 3.26 PCI/PNP Setup
26