Advertisement
ENGLISH
10
Using the bottle warmer with express warming setting
1
Put the mains plug in the wall socket (Fig. 3).
2
Place the bottle or container in the bottle warmer (Fig. 4).
3
Fill the bottle warmer with drinking water up to the level of the
milk/baby food in the bottle/container. In case of large amounts of
milk, the maximum level of water is approximately 1 cm below the
top of the bottle warmer. An accurate water level ensures correct
warming performance (Fig. 5).
4
Select a position in the express warming area. Consider the
beginning of this area as milk content volume up to 180ml and the
end of the area as milk content volume over and including 180 ml,
see the express warming reference table for you reference. (Fig. 6)
Baby food can also be warmed quickly if you select a position in this area.
Make sure to stir and check the food regularly during warming. Be careful
not to burn your fingers during stirring.
Note: The speed of warming milk/baby food depends on the amount of the
milk/baby food warmed and on its initial temperature, i.e. room temperature
(20°C) or fridge temperature (5°C).
5
The orange light goes on when you select a setting. This indicates
that the bottle warmer is on (Fig. 8).
Note: Whilst warming the milk circulates and heats evenly.
6
Check the warming reference table for the time required to warm
the milk. Remove the bottle/container from the bottle warmer
immediately after the warming is finished (Fig. 9).
Caution: Please make sure to check the milk/baby food on a regular
basis for temperature during warming.
Caution: If you leave the bottle/container in the bottle warmer too
long, the milk/baby food may become overheated.
Note: Due to the high variety of baby food consistencies, it is strongly
recommended to continuously stir and check while you are warming the baby
food for an optimal result.
Advertisement
