Compaq Presario 5070 Maintenance And Service Manual page 83

MSG index Product Description
Home Removal & Replacement
REMOVAL & REPLACEMENT
Processor &
goalposts
System Board Components
Memory
module
Celeron II Processor & Goalposts
Video
memory
This page shows the removal and replacement procedure for a Celeron II processor.
Battery
System
Click the link to see how to remove an
board
Heat sink
clip
I-O panel
System
board
components
index page
l
Maintenance and Service Guide
Compaq Presario 5000, 5100, and 5200 Series Computers
Troubleshooting
Jumper & Switch Information
AMD K6-2 or Pentium II
Illustrated Parts Catalog
Specifications
processor.
1 Perform preparation
procedures
2 Remove the hood
3 Remove the fax/modem
4 Open the system board
bracket
5 Locate the Celeron processor
CAUTION The processor
may still be
very hot if the
computer has
been running
recently.
6 Open the top lever of the
heat sink clip to release the
heat sink
7 Unplug the processor from
the system board and slide
out from the "goalposts"
To see how to remove the
goalposts, click this link.
If your goalposts are different from
those illustrated, you may need to
click on this link instead:
Alternative goalposts
To replace the Celeron II
processor, reverse the procedure
above.
IMPORTANT:
CAUTION:
installing a new
processor, see
Jumper and Switch
Information
the jumpers for the
processor. If the
processor is installed
with the incorrect
jumper settings, the
processor and
system board may be
damaged.
Ensure that
the processor
is properly
aligned in the
goalposts
before
plugging it
into the
system board.
Before
to reset