Network Configuration; Setting Up The Network Configuration - Panasonic DP-8060 Operating Instructions Manual

Network Configuration

Setting up the Network Configuration

Follow the procedure below if your network is not configured with the DHCP server, and the TCP/IP parameters must be
setup manually.
- IP Address
- Subnet Mask
- Default Gateway
Before executing the procedures
described below, make sure the Print
On Line LED is lit.
1 Press the Function key.
Print On Line LED
●
Please wait until the Print On Line LED is ON
before pressing the Function Key.
2
Select "GENERAL SETTINGS".
3
Select "09 Key Operator Mode".
4
4
Function Key
5
6
Enter the Key Operator's password
(8 digits), and then select "OK".
●
Default password is "00000000".
To change this password, open "50 Key
Operator Password" in the General Setting
(For key operator), and then re-enter the new
password.
Scroll to "05/11" screen, and then
select "22 DHCP Default".
If DHCP Default is set to "Yes",
change the setting to "No", and
then select "OK".
2
Select "23 TCP/IP Address".
1