Network Configuration
Follow the procedure below if your network is not configured with the DHCP server, and the TCP/IP parameters must be
setup manually.
- IP Address
- Subnet Mask
- Default Gateway
Before executing the procedures
described below, make sure the Print
On Line LED is lit.
1
Press the Function key.
Print On Line LED
●
Please wait until the Print On Line LED is ON
before pressing the Function Key.
2
Select "General Settings".
3
Select "09 Key Operator Mode".
1
4
Function Key
2
4
Enter the Key Operator's ID Code
(4 digits), and then select "OK".
1
●
Default identification code is "0000".
To change this identification code, please
contact system administrator.
5
Select "25 DHCP Default".
If DHCP Default is set to "Yes",
change the setting to "No", and
then select "OK".
1
6
Select "26 TCP/IP Address".
2
3
2