Pc With Wi-Fi Adapter - D-Link DSL-2750U User Manual

DSL-2750U Wireless N ADSL2+ USB Modem Router
User Manual

PC with Wi-Fi Adapter

1. To connect via 3G network: connect your USB modem to the USB port
side panel of the router.
!
If you need to connect or change a USB modem to another one when the router is powered
on, power off the device, connect the modem to the USB port, and power on the router.
2. To connect the router to a DSL line: connect a phone cable between the DSL port of the
router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of
the splitter. Then connect another phone cable between a phone jack and the ADSL IN port
of the splitter.
3. To connect the router to an Ethernet line: connect the Ethernet cable between any of four
Ethernet ports located on the back panel of the router and the Ethernet line.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Turn on your PC and wait until your operating system is completely loaded.
7. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in wireless NICs are
equipped with a button or switch that turns on/off the wireless adapter (refer to your PC
documents). If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.
5 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 26 of 174
Installation and Connection
5
located on the left