Table of Contents
Advertisement
3. How to connect the electronic flash
Connecting the underwater optical fiber cable
To connect the UFL-2 underwater flash (optional) to the Case using an underwater optical fiber cable
(optional), follow the procedures below.
How to connect the underwater optical fiber
cable
1 Remove the cap of the optical fiber cable
insertion slot.
2 Put the underwater optical fiber cable plug all the
way into the optical fiber cable insertion slot.
Setting of the digital camera
1 Set the RC mode of the camera to ON so that the camera's built-in flash is activated.
2 Load the camera in the Case with the camera's built-in flash popped up.
Refer to the UFL-2 instruction manual for the UFL-2 operation.
CAUTION:
When using a non-Olympus manufacturer's slave-type flash with underwater optical fiber cable, set the
camera's built-in flash to manual.
En
If the camera's built-in flash ratio is more than 1/64, the camera's built-in flash light may reflect in the lens port
and be taken into the picture.
EN 11
Advertisement
Table of Contents
