Table of Contents
Advertisement
4. How to connect the underwater flash
Connecting the underwater optical fiber cable
EN
To connect the UFL-2 underwater flash (optional) to the Case using an
underwater optical fiber cable (optional: PTCB-E02), follow the
procedures below.
How to connect the underwater optical fiber cable
1 Remove the diffuser.
2 Put the underwater optical fiber cable
plug into the optical fiber cable
insertion slot.
Insert firmly until it stops next to the
flash window cover.
3 Put the cap to the optical fiber cable
insertion slot when not in use.
Setting of the digital camera
Set the RC mode of the camera to ON so that the camera's built-in flash
is activated.
In case of UFL-2, turn the RC mode to OFF.
For details, refer to the instruction manual of UFL-2.
In case of UFL-1, plug the optical fiber cable in the same way.
Turn the RC mode of the camera to OFF.
EN 20
Advertisement
Table of Contents
