Table of Contents
Advertisement
8.
Put the rollers and the inner ring of the front bearing into place,
apply grease according to item 6. Put on the antirotation securing
washer and the first one of the KM4 nuts. Tighten the nut with the
other hook spanner see a) 6. until the pulley starts to rotate a little
stiffer than with a loose nut. Put on a new securing washer DIN462-
20. Screw on the second nut. Secure this nut with Loctite 243. Fix
the first nut with a hook spanner so that the adjustment doesn't
change and tighten the second nut as far as possible. Check again
the rotation of the pulley. No free play is allowable.
9.
Press the sheet metal securing washer into the grooves of the rear
nut.
10.
Fill the sealing cap with grease and put it into place.
11.
Install the drive belt and adjust it according to sect. 4.10.2.
12.
Reinstall the proximity switch and check its adjustment according
to section 1.15.16. Secure with lockwire.
13.
Reinstall the propeller and secure with lockwire according to sect.
4.10:6.
Necessary material
1. roller bearing
2. "
3. Nilos ring
4. "
"
5. securing washer
6. grease for bearings
Caution: Don't use another type of grease
Issued: October 2012
Copyright DG Flugzeugbau GmbH - any copy or publishing prohibited
Manual valid with the up-to-date cover page only
Maintenance Manual DG-1000M
32205B
320/32X
32205 JV
320/32 JV
DIN 462-20
SKF LGMT3
TN1000/22
4.21
Advertisement
Table of Contents
