Table of Contents
Advertisement
C
Removal of the lower landing gear fork 10FW11/1
1. Remove the main wheel see A.
2. Retract the landing gear.
3. Disassemble the gas spring from the left side of the undercarriage box see
item 0.
4. Extend the landing gear again.
5. Remove the 2 bolts M10 LN9037 which connect 10FW11/1 to 10FW10/1.
(Mark the bolts and don't mix them up when reassembling the parts).
6. Remove fork 10FW11/1.
D
Removal of the spring legs (parts 10FW16 and 10FW17)
1. Remove the main wheel see A.
2. Remove the bolts M8×62 LN9037 which connect the spring legs to the fork
10FW10/1.
3. Remove the spring legs.
4. If it is necessary to disassemble the spring leg to exchange a component,
the reassembly must be done according to diagram 8.
E. Removal of the drag struts 10FW255/1 (right), 10FW255/2 (left)
1 Disassemble the gas strut from the left side of the landing gear box see item
0
2 Remove the 2 bolts M8 LN9037 which connect the struts to fork
10FW10/1. Mark the bolts. Don't interchange the bolts during reassembly!
3 Remove the 2 bolts M8×40 LN9037 which connect the struts to the rear
fork 10FW254.
4 Remove the drag struts.
Issued: October 2012
Copyright DG Flugzeugbau GmbH - any copy or publishing prohibited
Manual valid with the up-to-date cover page only
Maintenance Manual DG-1000M
TN1000/22
4.7
Advertisement
Table of Contents
