Table of Contents
Advertisement
1.2.6
Pilot force reducing rubber-cord
The rubber cord (part No. 30091131 dia. 6 mm white) produces an elevator
stick force in push direction. If the trim efficiency of your glider in push
direction is reduced, you have to inspect the rubber cord.
The rubber cord is located on the left hand side behind the main bulkhead
below the baggage compartment floor. The rubber cord runs from bellcrank
5St19 to a fork beside the left hand front edge of the landing gear box.
The length of the rubber cord when loose should be 470 mm (18.5 in.).
If the cord is longer or worn it must be replaced.
The cord must be replaced at least every 6 years.
Issued: July 2014
Copyright DG Flugzeugbau GmbH - any copy or publishing prohibited
Manual valid with the up-to-date cover page only
Maintenance Manual DG-1000M
TN1000/23
1.4
Advertisement
Table of Contents
