Advertisement
Note: Custom characters are not saved when the printer is turned off.
ASCII
ESC & m n
n
a d
1
2
1
This command is used to define up to 256 character patterns and store the patterns in
RAM. The matrix size used to define the characters is 11 horizontal dot columns x 8
vertical dot columns. Used with Utility mode only.
The first portion of this command—ESC & NUL n
for the characters to be stored.
The second portion of this command—a d
character to be defined and stored.
Use NUL (00H, 0D) for parameter m. This parameter sets the area of RAM used to store
the data.
Parameter n
is used to set the location of the first character to be redefined and parameter
1
n
is used to set the location of the last character to be redefined.
2
If less than 256 characters are to be defined, all character locations (addresses) must be
consecutive from the starting character.
• n
, n
= 0 to 255 decimal
1
2
Parameter a sets the character type, according to the values assigned to its 8-bit definition.
• a = 0 to 255 decimal
Hexadecimal
... d
1B 26 m n
11
n
a d
... d
1
2
1
11
n
—is used once to set up the printer
1
2
... d
—is used repeatedly, once for each
1
11
Decimal
27 38 m n
n
a d
... d
1
2
1
11
Advertisement
