Advertisement
Item
Description
Page Width
Change to 8" if you are using 9-inch
continuous forms. For continuous forms
less than 9 inches wide, the page width
must be set using software.
Caution! If the page width is set
narrower than the continuous forms
being used, the printhead will print
directly on the platen: this can
damage the printhead.
Parity
Sets the type of parity your system uses.
Pin 18
Sets the signal on pin 18 of the parallel
interface to +5 volts or to open.
Pitch
Sets the character width in characters
per inch.
Ppr Out Override
Paper Out Override: Senses when less
than 1" (25 mm) of paper remains and
stops printing. Change to Yes to override
the sensor. Caution!! This can cause loss
of data and damage the printhead!
Print DEL Code
Change to Yes if you wish to print the DEL
code (decimal 27) as a solid box.
Print Mode
Sets the typeface used: Utility, NLQ
(Near letter Quality) Courier, NLQ
(Near Letter Quality) Gothic, or
HSD (High Speed Draft).
Print Suppress
If you wish to enable the print suppress
command, change the setting to Yes. If
you select Yes, the printer will ignore all
data after it receives the print suppress
command.
Prop. Spacing
Change to yes if you wish to engage
proportionally spaced printing.
Protocol
Switch to X-ON/X-OFF if that is the
serial interface protocol you are using.
Rcv. Buffer
Sets the size of the receive buffer.
Emulations Group(s)
All
Rear Feed,
Front Feed
All
Serial I/F
All
Parallel I/F
All
Font
All
Set-Up
ML only
Set-Up
All
Font
All
Set-Up
All
Font
All
Serial I/F
All
Set-Up
Advertisement
