JUKI LK-1900AN Engineer's Manual page 70

Indication Level
S Jump feed speed of XY
(Setting possible in the unit of
10 pps)
S XY feed forward / back speed
(Setting possible in the unit of
10 pps)
S When the power supply is
turned on, automatic preparation
is possible without pressing the
READY key.
S While the needle stays in an
upper position, a current is
maintained in the main motor to
make the needle hard to down.
U Method of XY enlargement/re-
duction scale rate setting (IP200
only)
U The origin is moved toward the
front by 5 mm.
S No. of pulses for work clamp
foot interlock wiper operation
S At preparatory state, time to
output thread tension can be set
up at the time of thread tension
setting.
S The head falling detector switch
can be disabled.
U This function sets whether or not
the calling of the pattern data is
operative.
S Initialization of model's specifi-
cations is executed.
U Grease-up error
U Pattern registration is carried
out.
U Cycle sewing registration is car-
ried out.
S Test mode is assumed.
Functions Setting range
100 to 4000 pps
100 to 4000 pps
0 : Normal
1 : Automatic preparation is oper-
ated when the power supply is
ON.
0 : Holding disabled
1 : Holding enabled
0 : % setting
1 : Size setting
0 : Standard
1 : 5 mm closer to the front
30 to 60
0 to 20
0 : Normal
1 : Head falling detector switch
disabled
0 : Calling inoperative
1 : Calling operative
0 : LK1900ANSS
1 : LK1900ANHS
2 : LK1900ANFS
3 : LK1900ANMS
4 : LK1901ANSS
5 : LK1902ANSS
6 : LK1902ANHS
7 : LK1903ANSS-301
8 : LK1903ANSS-302
9 : LK1903ANSS-311/BR35
10 : LK1903ANSS-312/BR35
11 : LK1900ANWS
The number of stitches is counted
based on drive, sewing machine.
– 58 –
State when Remarks
delivered
2000
500
0
0
0 Displayed only for the IP200 operation
panel.
0 This setting is needed when using the
LK1904 presser foot and patterns.
45
20
0
Setting de- Standard pattern Nos. 1 to 64 can be
pends on individually set. (Standard operation
the model panel)
used.
Setting Contents of the memory switches are
values are initialized to the state when delivered.
specified The thread tension of each standard
at left ac- pattern is initialized to the state when
cording to delivered.
models. All the registrations patterns and cycles
are deleted.
Only clearing possible with the RESET
key.
Clearing should be done after the
completion of grease-up action.