Hunter M3608-01 Instructions Manual page 13

Hood www.HunterFan.com
1.888.830.1326
Screw two housing assembly screws from Feed the wire plug through the center Insert the third screw, found in the
the hardware bag halfway into the hole of the hood, then wrap keyhole hardware bag, into place and then tighten
motor housing. It does not matter which slots around the screws and twist all three screws.
two screw holes you choose. counterclockwise.
Make sure the hood is securely attached to the
mounting plate. Failure to properly secure all 3
assembly screws could result in the switch housing
fixture falling.
13
M3608-01 • 05/09/16 • © 2016 Hunter Fan Company