Operation - Makita UT2204 Instruction Manual

1. Mixing blade
2. Shaft
1. Hex bolt
2. Shaft
3. Flat surface

OPERATION

When installing the mixing blades at two different positions (which is applicable
007103
only to the mixing blades allowed to do so), mount and secure the two mixing
1
blades on the flat part of the shaft with the hex bolts so that the same surface
of blades faces each other as shown in the figure.
2
007104
1
2
3
Mixing
CAUTION:
• Do not use to mix flammable material such as paint with thinner used as
solvent. Failure to do so may cause injury.
1. Hold the rear handle of the tool with one hand and the grip with the other
hand firmly, place the mixing blade under material fully and turn on the
tool after making sure work site safety.
2. Move the mixing blade up and down during the mixing operation so that
whole part of material can be mixed.
3. When finishing mixing, turn off the tool, make sure that the mixing blade
has come to a complete stop, and then pull it out of the vessel.
7