Position Of The Hand Pulley Grear - JUKI TL-2200QVP Service Manual & Parts List

2013.3.6 最終校正用

14. Position of the hand pulley grear

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
Left side of the frame
reference hole for machining
Disassembly
Remove gear A after
having drawn out the
main shaft.
70 mm
assembly
Insert screw No. 1 1 into the
tapped hole and tighten it so
that its head is flush with the flat
section at the position where the
end face of gear A is spaced 70
mm away from the center of the
machining reference hole in the
frame. Then, tighten screw No.
1 1 and screw No. 2 1 in the
written order.
Apply grease to the tooth sur-
face of gear A.
2 screw no. 2
1 screw no. 1
Point
Tighten the screw No. 1
with aligned with the flat
section of the main shaft.
* if the position of the
screw no. 1 is not
correctly adjusted,
the hand pulley can-
not work normally.
27
– –
Gear A
apply grease to the
tooth surface of gear
Tool to be used
Hexagonal wrench
key (2 mm)